Connecting A Existing Doorbell Button; Troubleshooting; Cleaning And Maintenance - SilverCrest HG00783A Instructions De Montage, D'utilisation Et Consignes De Sécurité

Connecting a existing
doorbell button (see Fig. J)
The separate bell button must not be connected to the existing door-
bell system. The battery must remain in the transmitter. The B and C
terminals are to this purpose with a two-core cable connected to the
bell push. The bell push may only be connected to the transmitter.

Troubleshooting

After the influence of extraordinary environmental conditions (e.g. a
strong electromagnetical field) the function of the product may be af-
fected. In this case, please take off the batteries of the transmitter and
the receiver for approximately 2 minutes. Then proceed again as
described in the section "Synchronising the transmitter / receiver".
Electrostatic discharges may lead to malfunctions. If such malfunctions
do occur, remove the batteries for a short time and then replace them
again. Then proceed again as described in the section "Synchronis-
ing the transmitter / receiver".

Cleaning and maintenance

Under no circumstances should you use liquids or detergents, as
these will damage the product.
32 GB/IE