Inserting/Replacing The Batteries; Initial Operation - Bosch GLL 2 Professional Notice Originale

OBJ_BUCH-2413-002.book Page 10 Tuesday, August 30, 2016 12:40 PM
10 | English
Assembly

Inserting/Replacing the Batteries

Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid 4, press on the latch 3 and fold the battery lid up.
Insert the batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery lid.
Always replace all batteries at the same time. Only use batteries from one
brand and with the identical capacity.
 Remove the batteries from the measuring tool when not using it
for extended periods. When storing for extended periods, the
batteries can corrode and self-discharge.
Operation

Initial Operation

 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or
variations in temperature. As an example, do not leave it in vehicles
for a long time. In case of large variations in temperature, allow the
measuring tool to adjust to the ambient temperature before putting it
into operation. In case of extreme temperatures or variations in
temperature, the accuracy of the measuring tool can be impaired.
 Avoid heavy impact or falling of the measuring tool. After heavy ex-
terior impact on the measuring tool, an accuracy check should always
be carried out before continuing to work (see "Levelling Accuracy").
 Push the switch for automatic levelling 2 to the
transporting the measuring tool. This locks the levelling unit, which
can be damaged in case of intense movement.
Switching On and Off
To switch on the measuring tool, press the On/Off button 5. Immediately
after switching on, the measuring tool sends a laser beams out of the exit
opening 1.
 Do not point the laser beam at persons or animals and do not look
into the laser beam yourself, not even from a large distance.
1 609 92A 21X | (30.8.16)
position when
Bosch Power Tools