Comfort Glow QDE1345 Manuel Du Propriétaire page 7

Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. and turn on the
power switch in the rear of the unit. Only operate heater in upright position with caster wheels attached.
When using remote control, please pull out the insulating film as the following steps.
OPERATING INSTRUCTIONS
1. Turn Main Power switch on rear of appliance to On.
2. Start and select working mode
Or
Or
Or
Or
Turn the heater on by pressing the ON/OFF button on the control
panel or by pressing the Power button on the supplied remote
control. (Main Power button on rear should be in the "ON "
position)
When unit is powered "OFF" the heating element will stop
running but the fan will continue to run for approximatly 3
minutes to disperse heat from inside of the unit.
Select a High Heat Mode: 1500 Watts
Select a Low Heat Mode: 750 Watts
Select Eco Mode: ECO mode is an Economic Energy Saving
Function. When ECO mode is chosen, the heater will fluctuate
itself from low to high heating power (watts) to maintain a
consitant 68°F (20°C)
Idicator lights on control panel will illuminate what setting is on.
7