Unpack Device; Electric Connection; Cleaning And Storage - Clatronic MZ 3434 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11

Unpack Device

• Take the device out of its packaging.
• Remove all packaging materials, such as foils, filling materi-
als, cable ties and cartons.
• Check that all accessories are included in the box.
NOTE:
Clean manufacturing residues and dust from the device as
described under "Cleaning".
Start-Up
1. Prepare the dish. Refer to the table below.
2. Place the rubber mat on a level, flat surface. Place the
glass container on the rubber mat.
3. Carefully insert the blade (blades down) on the glass pin in
the centre of the container.
4. Empty the desired foodstuffs into the container.
NOTE:
Do not overfill the container; otherwise the foodstuffs
cannot be properly chopped (quantities see table)!
5. Place the safety cover onto the container in such way that
the blade shaft rests in the recess. The safety cover is
properly positioned if it cannot be moved.
NOTE:
Before use, always check that the silicone seal fits
correctly.
6. Place the motor unit on the cover. In doing so, use the
recesses in the safety cover.

7. Electric Connection

Connect the mains plug to a properly installed and earthed
220-240 V~, 50/60 Hz wall outlet.
NOTE:
• The motor unit is fitted with a safety switch.
• If the device cannot be switched on, check that the
motor unit, safety cover and blade are fitted correctly.
8. Hold the motor housing in your hand and press the LOW
or HIGH button at the same time.
LOW = low speed
HIGH = high speed.
The unit starts up.
CAUTION:
This device is suitable for short time operation (KB) of
maximum 20 seconds. Leave to cool down for at least
2 minutes before using the device again.
NOTE:
PULSE OPERATION: Briefly press and release the
switch for pulse operation. Use the device in this mode
for maximum 1 minute. Leave to cool down for at least
2 minutes before using the device again!
9. After chopping, take your hand off the motor unit. Discon-
nect from mains power supply.
10. Remove the motor unit from the transparent container.
11. Lift off the safety cover and carefully remove the blade.
12. Now you can empty the contents in the transparent con-
tainer.
Crushing ice: The blade is suitable for crushing ice cubes. Fill
the container no higher than the 0.75 marking with ice cubes.
Only crush ice cubes in pulse mode.
Table
Food
Preparation
Boiled eggs
Shelled, quartered
Herbs
Walnuts /
Without nutshells!
hazelnuts
Almonds
Without shells!
Garlic
Peeled
Onions
2 cm cubes
Parsley
Wash, destalk
Bread
2 cm cubes
(breadcrumbs)
2 cm cubes,
Meat
without bones,
skin and sinews!
Parmesan
1 cm cubes
cheese
Cooking
1 cm cubes
chocolate
ice cold
Carrots
1 cm cubes
Obviously, you can chop other foodstuffs as well. Compare
with the hardness of the foodstuffs in this table to find out the
approximate chopping time; i.e. an apple is about as hard as an
onion. In this case follow the instructions in the table for "onions".

Cleaning and Storage

WARNING!
• After use and before cleaning always disconnect from
mains power supply!
• Do not submerge the motor unit in water! It could lead to
electric shock or fire.
• The blade is very sharp. Risk of injury! Handle the blade
with extreme care!
Max.
Max.
Quantity
Duration
300g
10 sec
(1/4 pieces)
15 sec
150g
or pulse
200g
15 sec
200g
15 sec
15 sec
200g
or pulse
5-10 sec
200 g
or pulse
30g
10 sec
15 sec
40g
or pulse
15 sec
200 g
or pulse
100g
15-20 sec
Max. 20 sec
100g
or pulse
10-15
200 g
seconds
21

Publicité

Table des Matières
loading

Table des Matières