HumanTechnik signolux LSA0002657 Mode D'emploi page 6

b) Using a pointed object (e.g. biro) carefully press now the
small pin on the left side (fig. 1 A).
c) Now you should be able to push up and remove the trans-
parent plastic face (fig. 1 A).
d) You can now open the small screw (fig. 1 B) using a small
Phillips screwdriver and remove the front of the doorbell
pushbutton behind which there is the PCB with the battery.
e) Insert the battery (coin cell CR 2032) into the plastic
support on the PCB (fig. 2 D).
D
E
Figure 2: Battery compartment
f) If you would like to replace a battery, remove the old
one with a small flat screwdriver from its plastic support
by lifting the edge slightly (fig. 2 E). Afterwards you can
insert a new battery. Kindly ensure correct polarity of
the battery.
g) Please refer to step 3 for the assembly of the doorbell
pushbutton.
English 5
2. Label name tag and insert
a) If you have not opened the housing yet, kindly proceed
as described under step 1 a) to c).
b) The transparent plastic face consists of two parts.
The labelled name tag can be inserted between them
(dimensions: 94 x 24 mm). Kindly ensure that the label-
ling is right way up. Kindly also keep in mind that the
name tag has a cutout that does not cover the light
diode or at least lets the light pass through.
c) Put the two transparent parts of the plastic face back
together so that the notches interlock.
d) Please refer to step 3 for the assembly of the doorbell
pushbutton.
3. Assembly
a) If you have changed only the name tag, proceed to step e)
b) Before assembling ensure that the small screw (fig. 1 B)
can grip at the right spot. If required turn one part of the
housing by 180°. Please make sure that the rubber gasket
sits correctly within the housing.
c) Insert the front face into the housing of the doorbell push
button and press both firmly together until the housing
parts lock in place.
d) Carefully drive in the small screw (fig. 1 B) with a small
Phillips screwdriver.
e) Now hold the doorbell pushbutton in such a way that
the small screw (fig. 1 B) is on the right.
f) At the right side of the pushbutton there is a small open-
ing (fig. 1 C) where the hinge pin of the transparent
plastic face can be inserted.