Safety Instructions - HumanTechnik signolux LSA0002657 Mode D'emploi

We would like to congratulate you on purchasing a »signolux«
signal system! You have chosen modern and reliable devices.
Kindly read the user manual carefully in order to start using
the device properly and to familiarise yourself with all the
possibilities of the system.
Package contents
Kindly check if all following parts are included:
- Doorbell-pushbutton
- Battery (CR2032)
- Double-sided adhesive strip
- User manual
- Warranty card
Should any parts be missing, kindly contact your specialist dea-
ler or the manufacturer directly.

Safety instructions

- Prior to putting the device into operation and using it, kindly
read this manual thoroughly and in full.
- Store this operating manual in a safe place so that it is also
accessible for other users at any time.
- When using power tools always follow the instructions of
the manufacturer and wear suitable protective equipment
(e.g. protective goggles).
- Kindly check before starting to drill if there are any hidden
electric cables and water pipes in the walls. In case of
doubt we recommend using a a cable detector.
Functioning principle
A »signolux« light signal system consists of at least one
transmitter (e.g. doorbell pushbutton) ad a »signolux«
receiver. Up to 8 transmitters can be integrated.
If e.g. the doorbell pushbutton is pressed, a radio signal
(radio impulses with 868,35 MHz) are transmitted to the
»signolux« receiver. This one signals the received signals
acoustically and visually with sounds and light signals.
Setup
1. Inserting and replacing the battery
In order to be able to insert the coin cell battery (type CR 2032)
you first have to open the battery compartment.
a) Place the doorbell pushbutton in such a way on the work
surface that the two rotation axes of the transparent
plastic face are at the rear (fig. 1 A and C).
A
Figure 1: Doorbell-pushbutton
C
B
English 4