Uline H-9286 Mode D'emploi page 10

TO TURN OFF UNIT:
Press ON/OFF Button
• The "Cool" circuit has an automatic three-minute
time delayed start if unit is turned off and on quickly.
This prevents overheating of compressor and
possible circuit breaker tripping. Fan will continue to
run during this time.
• Control will maintain set temperature within 2°F,
between 62°F and 86°F.
• There is a two-second delay for compressor shutting
down when selecting "Fan only." This is to cover the
possibility of having to roll through to select another
mode.
• After power outage, unit will memorize last setting
and return unit to same setting once power is
restored.
AIR DIRECTIONAL LOUVERS
These control air flow direction. Air conditioner has
louver type described below. (See Figure 3)
SLIDER TYPE
The louvers will allow user to direct air flow up/down and
left/right throughout room. Drag adjuster tablet until
desired left/right direction is obtained. Pivot horizontal
louvers until desired up/down direction is obtained.
(See Figure 3)
Figure 3
Adjuster Table
PAGE 10 OF 41
OPERATION CONTINUED
(6-Way)
USER WILL SEE:
FRESH AIR VENT CONTROL
• Recirculate inside air – vent closed. (See Figure 4)
Figure 4
• Draw fresh air into room – vent open. (See Figure 5)
• Exchange air from room – vent open. (See Figure 5)
Figure 5
0321 IH-9286