Items Requiring Special Attention; Emptying The Water Container - Indesit G85C Utilisation Et Entretien Et Notice D'installation

Items requiring special attention

Blankets and The drying requirements of blankets and bedspreads will, of course,
Bedspreads vary tremendously according to size and weight. Some, however are
simply too big. if you have difficulty getting them into the Dryer, the
machine will have difficulty drying them properly. Blankets (and
Garments) made from Acrylic fibres (e.g. Acilan, Courtelle, Orion and
Dralon) must be dried with special care on Low heat setting.
Overdrying should be avoided to ensure heat creasing does not
occur.
Permanently Your dryer will cope with such clothes very well, but you should
pleated or creased always read the manufacturer's drying instructions attached to the
garments garment before you begin.
Starched articles Starched articles should be dried together in the same load to avoid
the distribution of starch to non-starched items. You should use a
slightly heavier starch solution than you would when drying the items
on the washing line. Make sure that as much of the solution is
removed from the load as possible before placing it in the Dryer.
Remove the items from the dryer as soon as they reach ironing
dampness. If they are overdried the starch will powder, leaving the
fabric limp - which rather defeats the purpose of the exercise!
Fabric conditioner To make sure all your tumble dried clothes come out really fresh and
soft we recommend you use a liquid fabric conditioner in the final
rinse of your wash. A liquid fabric conditioner restores bounce and
softness and helps eliminate static cling.
WARNING: ON NO ACCOUNT SHOULD LIQUID FABRIC
CONDITIONER BE ADDED TO THE DRYER ITSELF.
Home Dry Garments with the ITCL Code
Cleaning Home Dry Cleaning Kits available.
The instructions supplied with the Home Dry Cleaning Kit must be
strictly followed.
may be cleaned using one of the

Emptying the Water Container

Water
Container
Plinth
Moulding
(not fitted to
all models)
Empty the water container after EVERY programme.
Failure to do this will result in the water container
becoming full and the load will not dry.
To Empty Water Remove plinth (where fitted) by slightly lifting and sliding to the left.
Container
Pull the container out of the dryer and empty it into a sink (or other
suitable drain).
Water
Container
Sink
7