Install Glass Panel ( Without Glass Models Only ) - Best UCB3I Serie Guide D'installation

3. PREPARE THE HOOD (
3.2 F 30" :
OR WIDE HOODS
Remove the 7 screws (A only) retaining the bottom panel, and set aside.
F 36" :
OR WIDE HOODS
Remove the 8 screws (A and B) retaining the bottom panel and set aside.
3.3
Using both hands, gently pull on the blower wheel to remove. Set blower wheel
aside.
4. INSTALL GLASS PANEL (SBN
The SBN hood models decorative glass panel is sold separately and has to be installed before completing the hood installation.
4.1
Carefully remove glass panel from its packaging.
Remove glass panel nuts (factory installed) from both studs and set aside.
4.2
Insert glass panel studs in hood front holes.
4.3
While holding glass panel, pre-tighten previously removed nuts by hand. Ensure glass panel is flush with top of hood and centered
from side-to-side.
Then, using a 3/8" socket, tighten nuts completely.
' )
CONT D
MODELS ONLY
HD0556
)
N
UT
S
TUD
5
HO0246
HO0347
B
A