Overview
Quick start instructions
Illustration
1 Connect spray/suction hose to the el-
bow,
Connect spray/suction hose to the ap-
pliance
2 Prepare cleaning solution,
Fill up the fresh water tank
3 Select operating mode
4 Cleaning
5 Empty the fresh water tank
6 Empty wastewater container
7 Fill fresh water tank (without detergent),
Flush appliance
8 Clean lint trap,
Clean fresh water sieve
9 Allow appliance to dry
Device elements
Illustration
1 Manual nozzle for upholstery cleaning
2 Hook for spray/suction hose
3 Holder for accessories
4 Power cord
5 Quick start instructions
6 Switch for spraying
7 Switch for vacuuming
8 Fresh water sieve
9 Casing
10 Nameplate
11 Steering roller
12 Spray hose connection
13 Suction hose connection
14 Nozzle mouth piece
15 Union joint
16 Cover
17 Fresh water tank
18 Carrying handle of the appliance
19 Bender
20 Lever on the manifold
21 Spray hose
22 Suction hose
23 Spray/suction hose
24 Dirt water reservoir, detachable
25 Carrying handle of the wastewater con-
tainer
12
26 Seal on the lid
27 Fluff filter
Check high power cable, extension ca-
bles and hoses for damage every time
before use.
Attaching the Accessories
Attach the elbow to the hand nozzle and
hand-tighten the union nut on the el-
bow.
Insert the suction hose into the suction
hose connection on the appliance.
Attach the coupling of the spray hose to
the spray hose connection of the appli-
ance and snap in place.
Connect the suction hose to the elbow.
Connect the coupling of the spray hose
with the manifold and snap in place.
Prepare cleaning solution
DANGER
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 50°C) will in-
crease the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
Fill up fresh water reservoir
Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Defoaming agent
Note: When cleaning previously sham-
pooed carpets, foam is generated in the
wastewater container. This formation of
foam can be prevented by adding a de-
foaming agent.
Put defoaming agent (optional accesso-
ry) into the wastewater container.
– 2
EN
Start up