Warning; Caution - Vortice TELENORDIK 5T Notice D'installation Et D'entretien

ENGLISH
!

Warning!

• Do not use this appliance for purposes other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged.
If in doubt contact a professionally qualified electrician
or Vortice*. Do not leave packaging within the reach
of children or the infirm.
• Certain fundamental rules must be observed when
using any electrical appliance, including: a) never
touch appliances with wet or damp hands; b) never
!

Caution!

this symbol indicates precautions that must be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not immerse the appliance or any of its parts in
water or other liquids.
• Regularly inspect the appliance for visible defects.
If any faults are found, do not operate the appliance;
contact Vortice* immediately.
• If the appliance malfunctions or develops a fault,
contact Vortice* immediately. Ensure that only
genuine original Vortice spares are used for any
repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice*.
• The appliance must be installed and the fuse
changed if necessary by a professionally qualified
electrician only.
• Ensure that the electrical system to which the
appliance is connected complies with applicable
standards.
1
this symbol indicates precautions that must be taken to avoid injury
A
touch appliances while barefoot; c) do not allow
young children or infirm persons to use the appliance
without supervision; d) supervise young children to
ensure that they do not play with the appliance.
• Store the appliance out of the reach of children and
infirm persons if you decide to disconnect it from the
power supply and no longer use it.
• Do not operate the appliance in the presence of
inflammable substances or vapours (alcohol,
insecticides, petrol, etc.).
• Only connect the appliance to the power
supply/socket if:
- the mains power specifications correspond to those
on the data plate (fig. 1-A);
- the electrical power supply/socket provides the
maximum electrical power required by the appliance.
If this is not the case, arrange for a qualified
electrician to make the necessary modifications.
• Use a multi-polar switch with minimum contact gaps
of 3 mm to install the appliance.
• The internal connection cable in this appliance must
never be replaced by the user.
• Remove the batteries and dispose of them at a
designated battery collection point before scrapping
the transmitter.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
cleaning the outside of the appliance, c) if the
appliance is not to be used for any length of time.
• This symbol indicates that the operation
must be carried out by a suitably qualified
person.
!
* (or an authorised Service Centre if you are outside
the UK-Ireland territory)
9