Lighting Instructions; Lighting The Burner - Coleman 9406 Serie Manuel D'assemblage, D'entretien Et D'utilisation

1. Regularly check the burner venturi tube for blockage from
an insect nest. Read "Cleaning the Venturi" in the section
titled "Care, Maintenance, and Cleaning", and also the
section titled "Troubleshooting".
2. Check that the burner tube [A] is set over the regulator
outlet [B] correctly. The orifice [C] must be inside the venturi.
(Fig. 25)
3. Use only the gas specified.
4. Keep the grill on a level surface.
B C
REPRESENTATIVE ILLUSTRATION
DO NOT add charcoal or lighting fl uid!

Lighting Instructions

WARNING
THE FOLLOWING RULES MUST ALWAYS BE
FOLLOWED IN THIS ORDER (FIG. 26):
1. OPEN THE GRILL LID! Any attempt to light the grill with
the lid down could cause an explosion.
2. Check that the burner control knobs are turned to "OFF".
3. DO NOT stand with your head or arms over the grill.
A
CAUTION

Lighting The Burner

Before lighting the appliance, pour a small amount of water into
the water pans. Monitor water level during use, making sure a
small amount remains in pans while operating grill. (Fig. 27)
NOTE: The yield of water must not exceed the maximum level
marked inside the water pan.
Fig. 25
INSTASTART™ Electronic Ignition
1. Push and turn control knob 90 degrees counterclockwise
to open then push igniter button repeatedly until burner
lights. (Fig. 28)
NOTE: If igniter fails to light grill, use match to light burner.
See match light instructions. If the grill is wet, the igniter
may not spark.
2. Adjust flame with control knobs. (Fig. 29)
Match Lighting
1. Strike and place the burning long wooden match (or use the
Fig. 26
match extension or a butane lighter with extension) through
the spaces in the grill grates near the ports of the burner.
(Fig. 30)
2. Push and turn control knob 90 degrees counterclockwise to
open burner.
3. Repeat steps 1 and 2 to light the second burner.
English - 8
Maximum Level
Control Knobs
Electronic
Igniter Button
Fig. 27
Fig. 28
Fig. 29