Installing 1 Lb. Propane Cylinder - Coleman 9949A Serie Manuel D'assemblage, D'entretien Et D'utilisation

Installing 1 lb. Propane Cylinder

NOTE: Your 9949 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
Only cylinders marked "Propane" must be used.
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
• NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
Tighten by hand only. DO NOT use tools.
■ Before attaching
propane cylinder make
sure burner valves are in
the OFF position.
(Fig. 15)
■ Remove plastic cap
from top of propane
cylinder and screw
cylinder into regulator
hand tight. (Fig. 16)
■ Press on cylinder
support on back of grill
and swing out. (Fig. 17)
■ Screw regulator into grill
hand tight. (Fig. 18)
■ Place cylinder into
cylinder support.
(Fig. 19)
WARNING
WARNING
DANGER
CAUTION
Fig. 17
Fig. 18
■ Never operate grill with
propane cylinder in an
inverted position. (Fig. 20)
■ To open lid, move lever
to OPEN position and lift
up. (Fig. 21)
■ Place a grill grate,
griddle, or stove ring
over each burner.
(Fig. 22, 23, and 24)
Grill Grate
Fig. 15
Fig. 16
Fig. 23
DO NOT operate the grill with side tables in storage position.
Damage will occur and void the warranty.
■ To extend side tables,
grasp hold of side
tables on bottom of grill
and slide out until fully
extended. (Fig. 25)
English-7
Fig. 19
OPEN
Fig. 22
Griddle
Fig. 24
WARNING
Fig. 25
Fig. 20
LOCK
Fig. 21
Stove Ring