Recommendations; Before Assembly; About The Inflatable Frame - Trigano DIABLO 6 Notice De Montage

RECOMMENDATIONS

• Assemble the tent at home before setting off on your trip in order to familiarise yourself with its
assembly and ensure you have not forgotten anything.
• Choose preferably a smooth, level plot and remove all stones, twigs, etc...
• Avoid placing the entrance towards the wind.
• Condensation (natural phenomenon) is caused by the humidity given off by the occupants,
the air and ground. Droplets therefore form on the inside surface of the tent and may give the
impression that the tent is leaking, but this is not the case!
• In order to limit this condensation, simply air the tent as much as possible using the double
doors with mosquito netting.

BEFORE ASSEMBLY

• Remove all items from the bag and place them on the ground.

ABOUT THE INFLATABLE FRAME

• The frame of the DIABLO 6 tent is composed of 3 inflatable beams.
• These inflatable beams are placed in the zipped covers. They are therefore easy to replace.
• The beams are made of polyurethane (TPU), a material
which resists wear and its porosity to air is almost zero.
• To provide efficient protection against bursting, each TPU
beam is covered with a high-resistance protection made of
polyethylene. This cover is closed with a zipper.
ATTENTION
THE 2 PULLS OF THE ZIPPER
ARE ATTACHED TOGETHER
WITH A PLASTIC LINK. THIS
LINK MUST NEVER BE REMO-
VED AS THIS WILL RESULT IN
THE TUBE BURSTING DURING
INFLATION.
Notice TRIGANO DIABLO 6.indd 11
Sleeve
Cover
- 11 -
ENGLISH
Zip
21/09/2018 10:02