Care And Maintenance; Glass Cleaning; Fireplace Surface Cleaning; Servicing - Furrion FF23SW15A-BL Manuel D'instructions

Care and Maintenance

WARNING
● Always disconnect the fireplace
from the main power supply
before performing any routine
maintenance.
● Always utilize a qualified technician
if assistance is required.
● Always install genuine Furrion
replacement parts, which are
available from your authorized
dealer.

Glass Cleaning

CAUTION
GLASS INFORMATION
● Never strike or slam the glass.
● Never use abrasive cleaners to
clean the glass.
● Never attempt to operate this
fireplace if any glass component is
broken.
● Always utilize a qualified service
technician to replace broken glass
components and always install
genuine Furrion tempered glass
replacements, which are available
from your authorized dealer.
The glass is cleaned in the factory
during the assembly operation. The clear
door may collect dust particles during
shipment, installation or handling, these
can be removed by dusting lightly with a
clean dry cloth.
To remove fingerprints or other marks,
the clear door can be cleaned with a
damp cloth. The clear door should be
completely dried with a lint free cloth
to prevent water spots. To prevent
11
scratching, do not use abrasive cleaners
or spray liquids on the clear door
surface.

Fireplace Surface Cleaning

Metal painted parts may be cleaned
using a clean, damp cloth. Never use any
abrasive cleaners and chemical agents
as these may damage the paint finish.
Cleaning of the screen diffuser is to
be done using only water and a lint
free cloth. DO NOT use any abrasive
household cleaners as these products
will damage the diffusing screen.

Servicing

The motors used on the fan heater and
flame blower are pre-lubricated for
extended bearing life and require no
further lubrication. However, periodic
cleaning/vacuuming of the appliance
and around the air intake and exhaust is
recommended.