Remote Control Handset; Master Volume - NAD C300 Manuel D'installation

0 0
48 views
 
NAD C300
Uploaded by juvior
C300 Stereo Integrated Amplifier GB Owner's Manual F
D E I P S Manuel d'Installation Bedienungsanleitung
Manual del Usuario Manuale delle Istruzioni Manual do
Proprietário Bruksanvisning I...
   
Save Embed Share Print

REMOTE CONTROL HANDSET

MUTE
Press the MUTE Button to temporarily switch off the sound to the
speakers and headphones. Mute mode is indicated by the
Power/Protection LED flashing. Press MUTE again to restore
sound. Mute does not affect recordings made using the Tape
outputs.

MASTER VOLUME

or
setting. The motorised Volume Control on the front panel will
indicate the level set.
NOTE: Direct sunlight or very bright ambient lighting may affect
the operating range and angle for the remote control handset.
NO SOUND
NO SOUND ONE CHANNEL
WEAK BASS/ DIFFUSE STEREO IMAGE
REMOTE CONTROL HANDSET NOT
WORKING
GB
POWER/PROTECTION LED STAYS RED
UPON TURNING POWER ON
POWER/PROTECTION LED TURNS RED
DURING OPERATION
RELATED TITLES
The Selection
Full description
respectively increases or decreases the Volume
Problem
• Power AC lead unplugged or power not
switched on
• Tape 1 Monitor selected
• Mute on
• Headphones inserted
• Balance control not centered
• Speaker not properly connected or
damaged
• Input lead disconnected or damaged
• Speakers wired out of phase
• Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows
obstructed
• IR receiver in direct sun or very bright
ambient light
• Loudspeakers cabling has a short-
circuit
• Amplifier has over-heated
• Overall impedance of loudspeakers too
low
The Glass Castle:
A Memoir
TROUBLESHOOTING
Cause

Alexander Hamilton
Solution
• Check if AC lead is plugge
power switched on
• De-select Tape 1 Monitor
• Switch off Mute
• Disconnect headphones
• Center Balance control
• Check connections and sp
• Check leads and conn
• Check connections to a
the system
• Check or replace batterie
• Remove obstruction
• Place unit away from dire
amount of ambient light
• Turn amplifier off and che
loudspeaker cable connec
speakers at amplifier's ba
loudspeakers. Turn ampli
• Turn amplifier off. Make s
ventilation slots on top an
amplifier aren't blocked.
has cooled down, turn ba
• Ensure the overall loud
impedance isn't below 4 o