Snapper 1695907 Manuel De L'opérateur page 17

4. Insert the safety key (A, Figure 10) into the safety key slot and
push fully in to the RUN position.
5. Turn the choke knob (B) fully clockwise if engine is cold.
NOTE: Do not use the choke to start a warm engine.
6. Push the primer button (C) two times.
NOTE: Do not use the primer to start a warm engine.
NOTE: Ensure that electric extension cord is removed from
the power receptacle.
C
B
A
Inserting Safety Key
7. Rewind Start: Firmly hold the starter cord handle (A, Figure
11). Pull the starter cord handle slowly until resistance is felt,
then pull rapidly.
WARNING: Rapid retraction of the starter cord (kickback)
will pull your hand and arm toward the engine faster than
you can let go. Broken bones, fractures, bruises, or
sprains could result. When starting engine, pull the
starter cord slowly until resistance is felt and then pull
rapidly to avoid kickback.
NOTE: If the engine does not start after three attempts, see an
authorized dealer.
8. Electric Start: First connect the extension cord to the power
cord receptacle and then into a wall receptacle. If additional
extension cord is required, make sure it is three-wire.
WARNING: If the extension cord is damaged, it must be
replaced by the manufacturer (or its service agent) or a
similarly qualified person to avoid a hazard.
en
9. Electric Start: Depress the starter push button (A, Figure 12).
After you start the engine, first disconnect the extension cord
from the wall receptacle and then from the power cord
receptacle (B).
A
Starting with Cord Handle
Figure 10
Starting with Electric Start
IMPORTANT: To extend the life of the starter, use short starting
cycles (five seconds maximum). Wait one minute between
starting cycles.
NOTE: If the engine does not start after three attempts, see an
authorized dealer.
OPERATION
Figure 11
A
B
Figure 12
17