Manual Operation (Cool, Dry, Heat); I-See Control Operation - Mitsubishi Electric MSZ-FA25VA Notice D'utilisation

MANUAL OPERATION (COOL, DRY, HEAT)

To select the COOL, DRY or HEAT mode:
¥
Press the
ø
Select the operation mode by pressing the
Each time this button is pressed, the operation mode is changed in sequence:
To stop operation:
■
Press the
After the operation mode is set once, the operation starts in the
same mode as the one set previously from the next time by simply
pressing the
■
When the set temperature is to be changed:
TOO
TOO
WARM
• Press the WARM button to lower the temperature. One press lowers the temperature by about 1°C.
TOO
• Press the TOO button to raise the temperature. One press raises the temperature by about 1°C.
COOL
COOL
In DRY operation
• The temperature control (temperature setting) cannot be done.
• The room temperature is slightly lowered in this operation mode.
If the air conditioner doesn't cool or heat effectively...
If the fan speed is set to Low or AUTO, sometimes the air conditioner may not cool or heat the air effectively.
In this case, change the fan speed to Med. or upper.
Fan speed: Low or AUTO
ON/OFF
button.
(AUTO) (COOL) (DRY) (HEAT)
→ → →
ON/OFF
button.
button.
ON/OFF
Change the fan speed.
Fan speed: Med. or upper
i-see CONTROL OPERATION... SENSIBLE-TEMPERA-
TURE CONTROL
The air conditioner controls the temperature you perceive ("sensible temperature") in accordance
with the room temperature as well as floor/wall temperatures ("i-see control operation").
To control the room temperature instead of the sensible temperature, cancel the i-see control operation.
MODE
button.

i-see control operation

The sensors constantly measure the
room and floor/wall temperatures to
automatically adjust to the set temperature
by estimating the temperature actually
perceived by a person inside the room
("sensible temperature").
Advantages
•
The air inside the room is conditioned quickly
to a comfortable condition.
•
The room will not become too cold or hot
even when the air conditioner is kept on
for a long period.
•
The air conditioner will not overcool or
overheat, which means you can save on
electricity.
To start i-see control operation:
■
During MANUAL COOL or MANUAL HEAT mode, press the
i-see button with a thin stick.
NOTE:
The i-see control operation is activated when the remote controller
is first used following replacement of the batteries or resetting of the
remote controller.
To release i-see control operation:
■
Press the i-see button with a thin stick again during
operation.
NOTE:
If the air conditioner is turned off without canceling the i-see control
operation, the i-see control operation is activated the next time the air
conditioner is turned on.
Wall
temperature
Humidity
Floor
Approx. 20%
temperature
Approx. 50%
Approx. 30%
Contributions to sensible temperature
Wall/floor temperatures
Room temperature/air temperature
Room
temperature
Sensible
temperature
7