Setup
Hydraulic Connection
1. Clean all couplers, threaded fittings, ports and the
area around all ports.
2. Remove any dust plugs from couplers.
3. Hand-tighten all couplings firmly (until all threads are
fully engaged). Do not use tools.
Greenlee Tools, Inc.
980 Hydraulic Power Pump
Electrical Connection
Electric shock hazard:
• Do not modify the plug provided
with the tool.
• Connect this tool to a grounded
receptacle on a 20-amp GFCI-
protected circuit.
Failure to observe these warnings can
result in severe injury or death.
This tool must be grounded. In the event of a
malfunction or breakdown, an electrical ground provides
a path of least resistance for the electric current. This
path of least resistance is intended to reduce the risk of
electric shock.
This tool's electric cord has a grounding conductor
and a grounding plug as shown. Do not modify the
plug. Connect the plug to a corresponding 20-amp
GFCI-protected receptacle that is properly installed
and grounded in accordance with all national and local
codes and ordinances. Do not use an adapter.
Plug
Extension Cord Specifications:
Diameter ......................................... 2.5 mm
Length .......................................... 30 meters (100 feet)
Use only three-wire extension cords. Use of an
inadequate extension cord will cause the motor to stall.
6
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Receptacle
(12 AWG)
2