SLV VALETO 420040 Mode D'emploi page 2

®
420040 VALETO SMART HOME SYSTEM Motion Sensor
ENGLISH
The VALETO® Motion Sensor is PIR motion detector with a light sensor enabling a the
control of light within a VALETO®setup by detecting motion.
Technical Data
Battery: CR2450 (3V)
Transmitting frequenzy: 2,4GHz
Transmission power: 3,6mW
Transmission range: 30 m
Installation / Operation
The Valeto® System may only be operated in private areas and not in commercial
areas.
The product may only be used in dry rooms.
The product is suitable for installation on a wall.
Consider the mounting direction and the detection area of the sensor!
Install the product as shown in the figure. Remove the isolating strip from the
battery.
Settings of the sensor
Dusk setting
The sensor is active, as long the surrounding light does not exceed a
luminance of 10 lux.
24 H The sensor is permanently active.
Switch‐on time
1 – 5 – 10 Minutes
Intergration into the VALETO® App
Notice: For this at least one Gateway must be integrated within the app.

Open the VALETO® app on a mobile device.

Choose the Gateway to which the device should be added.

Choose <Add device> within <Settings>.

Push button (A) on the device for five seconds. The LED on the front flashes.

Choose <Smart Device> next. After that a search run is started.

When the search run is finished choose the displayed device.

After a period of 90 seconds the device is ready for operation.
Removing from the VALETO® App

Open the VALETO® app on a mobile device.

Choose the Gateway from which the device should be removed.

Within <Settings> choose <Device Mangement> and then <Sensor>.

A list of connected sensors appears.

Applying a long push on the sensorthat is supposed to be removed leads to the
details of the sensor.

Choose <Settings> and then <Delete Device>.
Changing the battery

Use only batteries of type CR2450(3V).

Open the battery compartment on the back.

Remove the used battery (see note on used batteries).

Insert the batteries considering the right polarity into the battery compartment.
Wrong polarity may lead to explosion and/or chemical burn!

Close the battery compartment.
Disposal (European Union)
 Do not dispose the product with the regular household waste! Products marked with
this sign must be disposed according to the directive(WEEE, 2012/19) on electrical
and electronic devices at local collection points for such devices!
 Notes on used batteries:
Do not throw used batteries in the regular household waste. Discard the batteries at
a public collecting point or at the retail store where the batteries were purchased.
Return only completely discharged batteries. Cover the terminals before storage or
disposal to avoid short‐circuits.
Hereby, SLV GmbH declares that the radio equipment described here is in compliance
with Directive 2014/53/EC. The full text of the EU declaration of conformity is available
at the following internet address:
www.slv.com/jump/420040
This radio equipment may be distributed in all countries of the EU.
420040 08.12.2017 © SLV GmbH, Daimlerstr. 21‐23, 52531 Übach‐Palenberg,
Germany, Tel. +49 (0)2451 4833‐0. Technical Details are subject to change.
Made in China.
A
+
CR2450
3V
2
1
1 2 3 4 5 6
1 2 3 4 5 6
5
4
3
2
1
1
2
3
4
5