MITACA IM9 Mode D'emploi page 22

Starting/warming up the coffee machine
•Use only capsules that are specific for this model
•Plug the coffee machine into an electrical socket
•Power the coffee machine by turning on the main switch (9)
(Fig.4)
• The luminous frames of the buttons (A) and (B) start to blink;
when they appear with a fixed light the machine is ready for use
(Fig.4)
Energy saving function
If the machine is left switched on and is not used, after about 10
minutes the energy saving function is activated and the luminous
frame of button (A) blinks intermittently.
To use the machine again press one of the buttons (A) or (B) and
wait for it to heat up; when the luminous frames of the buttons (A)
and (B) appear with a fixed light the machine is ready for use.
Rinsing the machine/inner circuits
The coffee machine should be rinsed both at its very first use and when
it has been inoperative for a long spell of time. By performing this quick
procedure, you will ensure that all inner circuits are rinsed.
•Ensure that there are no capsules inside; power on the machine via
the main switch(on the back) (9)
• Close the small cup support (3) and place a large empty cup
under the dispensing spout. (Fig. 5) When the luminous frame
of the buttons (A) and (B) appears with a fixed light the machine
is ready for use. Press a button (A) or (B); the machine dispenses
water, press the button again when you have obtained the desired
amount of water. (Fig. 6)
The machine is rinsed when at least 3 glasses of water have been
dispensed.
NOTE
open the support (3) to prepare espresso coffee correctly and to
use small cups (Fig. 7). To use large cups, close the support (3)
and place the cup directly on the grid of the drip tray (5) (Fig. 5)
3
Fig. 7
Fig. 4
Fig. 5
Fig. 6
20
9
B
A
3
B
A