Lower Back Panel Section Installation With Threaded Fittings On Finished Walls - Stiebel Eltron DHE 18/21/24 Utilisation Et Installation

INSTALLATIoN
Installation alternatives
Only if using the "solder fitting" accessory and with precise
adherence to all installation dimensions:
f Break the sealing lips out of the cover guides. f
f Position the back panel guides on the pipes. Push them to- f
gether. Then push the guides against the back panel as far
they will go.
f Secure the lower back panel section with a screw. f
Note
You can use the cover guides with sealing lips to com-
pensate for a slight offset of the connection pipes and/
or if using the "press fitting" accessory. In this case, the
back panel guides are not fitted.
www.stiebel-eltron.com
13.8 Lower back panel section installation with
threaded fittings on finished walls
3
1
1 Lower back panel section
2 Connection piece in the standard delivery
3 Screw
If using threaded fittings on finished walls, the lower back panel
section can also be installed after fitting the taps. To do this, carry
out the following steps:
f Cut open the lower back panel section. f
f Fit the lower back panel section by bending it out at the sides f
and guiding it over the pipes.
f Insert the connection pieces into the lower back panel sec- f
tion from behind.
f Click the lower back panel section into place. f
f Secure the lower back panel section with a screw. f
2
DHE | 89