Stiebel Eltron DHE 18/21/24 Utilisation Et Installation page 77

INSTALLATIoN
Installation
f Open the appliance by holding the fascia at the side and pull- f
ing forwards away from the appliance cover. Undo the screw.
Pivot open the appliance cover.
f Remove the back panel by pressing the two locking tabs and f
pulling the lower back panel section forwards.
Preparing the power cable on unfinished walls, for connection
from below
160
30
1 Cable entry installation aid
f Prepare the power cable. f
www.stiebel-eltron.com
Fitting the wall mounting bracket
f Mark out the holes for drilling using the installation tem-
f Drill the holes and secure the wall mounting bracket at 2
f Fit the wall mounting bracket.
1
Installing the twin nipples
f
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
f
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
f
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
DHE | 77