Operation Panel - KIRAMI Tubtainer 2 Instructions D'utilisation

© Kirami Oy, Finland
Setting the operation parameters:
When the unit is powered up but not running, press "
(parameters 0-A, see: Table 1 – )
Press "SET" to enter current parameter setting. Press "
•
press "SET" again exit the current parameter setting.
If there over 8 seconds between pressing button you will exit the parameter interface menu.
•
If the pump is running, press "
•
cannot change the paramaters, exluding the water temperature parameter 0.
If the device is running teh screen show the current water temperature. If the device is in standy by
•
mode (not running) the screen will show the current time.
Tubtainer 2 heater/filter system
45/108

OPERATION PANEL

Image 13 – Operation panel
" or "
" or " " to enter operation parameter check interface. Here you
22.12.2020
" to enter operation parameter interface.
" or " " to set data for parameter and
P 9/17
AGE