During Operation - NEC Vector Engine 2.0 20B-P Guide De Mise En Route

During operation

Avoid contact with the product during thunderstorms.
Do not touch any part of the product including the cables when a thunderstorm is approaching. Also, do not
connect or disconnect any devices. There may be a risk of electric shock from lightning strike.
Keep animals away from the product.
Keep animals such as pets away from the product. Pet hair or other waste enters the product, which may
cause a fire or electric shock.
Do not place any object on top of products.
Separating the product from the rack may result in personal injury and damage to nearby personal belongings.
Do not remove the product from the rack while it is running.
Do not pull out or remove the product from the rack while the product is running. In addition to causing
equipment to not function properly, separating the product from the rack may result in personal injury.
Anti-static measures
This product contains static-sensitive electronic components. Take the measures below to avoid a failure caused by static electricity
when installing or uninstalling any optional device.
Wearing anti-static wrist strap or anti-static gloves
●
Wear a wrist strap on your wrist and connect the wire to the chassis. If there is no wrist strap, touch an unpainted metal surface of
the chassis connected to the ground to discharge static electricity from your body before touching the component. Touch the metal
part occasionally to discharge the static electricity while working on the component.
Checking the workplace
●
- Work on an anti-static floor or concrete floor.
- If you work on a place where static electricity is likely to be generated (e.g. carpet), be sure to provide anti-static protection.
● Using the work table
Place the server on a mat with electrostatic discharge (ESD) protection.
Clothing
●
- Do not wear wool or synthetic clothes.
- Wear anti-static shoes.
- Remove any kind of metal accessories such as a ring, bracelet or wrist watch.
Handling of components
●
- Keep the component in an anti-static bag until you install it to the server.
- Hold the component by the edges to avoid touching any terminals or mounting parts.
- Place the component in an anti-static bag when storing or moving it.
Handling of cables
●
When connecting a cable (e.g., Power cable, LAN cable), static electricity may also be charged due to friction against the floor.
Connecting the charged cable with an I/O device may cause damage to the devices in the system. It is recommended to use a
product such as electrostatic discharge kit to eliminate the static charge before connecting the cable.