BaBylissPro FOILFX02 FXFS2 Série Directives D'utilisation page 4

NOTE: When cleaning your shaver, make sure the unit is turned off.
CAUTION!
• DO NOT run shaver or cutters under water. Use only the small brush (included)
to clean.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use
strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
• The shaver should not be used until it has completely dried.
• Be sure voltage is correct before plugging in. For connection to power supply
not in the U.S.A. use an attachment plug adapter of the proper configuration
for power outlet. The included adapter automatically adjusts to the input
voltage. DO NOT USE A VOLTAGE CONVERTER.
TO REPLACE FOIL HEAD ASSEMBLY
1. Remove the foil head assembly by pressing the round release button located
on the side of the shaver. Hold the foil head assembly on both sides and
lightly pull away from shaver unit.
2. Take the replacement foil head assembly (FXRF2/FXRF2G/FXRF2RG) out of
package. Align the replacement foil head assembly over the cutters. Carefully
move the replacement foil head assembly down towards the shaver unit until
it firmly snaps into place. BE CAREFUL NOT TO DAMAGE THE FOILS OR
CUTTERS WHILE INSTALLING.
TO REPLACE CUTTERS
NOTE: Always replace the cutters and foil head assembly at the same time.
1. To remove cutters, place your fingers on each side and gently pull up and
away from drive shaft.
2. To replace cutters, remove the new cutters (FXRF2/FXRF2G/FXRF2RG) from
the packaging. Align cutter about the drive shaft and lightly push down until it
snaps into place.
3. Replace the foil head assembly, turn shaver on to ensure it is working
GOOD
properly.
FXFS2 Series IB-15500E.indd 7-8 FXFS2 Series IB-15500E.indd 7-8
BAD
Daily Maintenance:
1. Press the release button on the sides of shaver and remove the head
assembly (see Fig. 1 & 2).
2. Use cleaning brush to whisk away any debris on and around cutter (See
Fig. 3).
3. Snap the head assembly closed (see Fig. 4)
Fig. 1 Fig. 2
Weekly Maintenance:
1. Repeat steps 1 – 3 from the Daily Maintenance cleaning steps.
2. Rinse the head of the shaver under running water (see Fig. 5).
NEVER submerge the shaver in water.
3. Leave head open for drying.
4. Press the shaver head back into place
(see Fig. 4).
BATTERY REMOVAL
When your rechargeable shaver reaches the end of its useful life, the Ni-Mh
batteries must be removed from the shaver and be recycled or disposed of
properly in accordance with your state and local requirements. If this is not
required by law, you may elect to dispose of the shaver with the batteries.
To remove the rechargeable battery:
1. Unplug the sha ver.
2. Run sha ver until motor stops.
3. Remove foil head from shaver (press release button and pull head away
from shaver body).
4. Remove screw from bottom housing. Remove 2 screws from metal plate
under cutters.
Fig. 3 Fig. 4
Fig. 5
Washable
2021/3/25 10:46 AM 2021/3/25 10:46 AM