Control Functions - GLOBBER ONE K Manuel D'utilisation

ENGLISH

3 - CONTROL FUNCTIONS

Screen functions
Battery charge level indicator
LCD screen
On/Off function
Long press the power button to turn on/off the power.
Acceleration
Press the right acceleration button to start and accelerate. Kick start to activate the motor.
Braking
Press the brake lever on the left side of the handlebar to engage the rear wheel disc brake. The action of the brake lever will
simultaneously engage the electromagnetic motor brake of the front wheel.
To help braking you can also operate the rear fender using the foot.
Setting the speeds
Short press the function key to directly adjust the speed.
Beginner mode: the symbol "D" is not visible on the screen (Max. speed: 10 km/h)
Normal mode: the "D" symbol is displayed in white on the screen (Max. speed: 15 km/h)
Sports mode: the "D" symbol is displayed in red on the screen (Max. speed: 25 km/h)
Headlights
Press the function button twice shortly to turn the front and rear lights.
The taillights have a brake light function and engage with each action of the brake located on the handlebar (even when the
headlights are not on). To turn off the headlights, press the function button twice again.
Warning. If the electric scooter is overheated (temperature 80° C) the temperature warning light comes on and an
audible signal sounds (this can happen during excessive use). You must then stop using the electric scooter and wait
for the alarm to go off and the audible signal. You can either leave the scooter on to wait for the end of the signal or
put the scooter on OFF and then turn it on again after a few minutes.
4 - TIPS FOR USE/CAUTION
Before and after using your appliance: check all the connections: the brake, the steering column quick-locking system and
the wheel axles must be correctly adjusted and undamaged. Also check wheel wear.
Check the height of the steering system and make sure that the nuts are tightened and the handlebars and front wheel are
perpendicular.
Check that the kick stand is fully folded before starting. When parking check that the kickstand is properly unfolded, the unit
must be parked on a flat ground to avoid any risk of falling.
6
Fault display
Brake handle
Bell
Speedometer
Temperature indicator
Speed mode
The unit display
Function button to switch on/off the LED light
On/Off button
Throttle button