WAGNER Handi-Roller Mode D'emploi page 11

Handi-Roller ®
STORAGE
Turn the locking collar next to the trigger counterclockwise until the main tube slides off the plunger.
Pack a generous amount of petroleum jelly around and in between the O-rings on the plunger.
Clean and pack a generous amount of petroleum jelly on the seal (a), O-ring (b) and other indicated be-
aring areas (c) of the arm.
PROBLEM
A. There is paint leakage on the
roller arm assembly
B. Plunger is difficult to pull/push
C. The fill tube will not fill with paint 1. Paint residue on fill valve components
or paint leaks from fill valve
Item Description
gs
1,3
Roller core and cap*
2 Roller cover
4,5,6 Seal, roller arm and O-ring*
4,6 Seal and O-ring
7 O-ring
8 Main tube
9 Plunger
10 Locking cap
11 Retainer disk
12 Duckbill valve
13,14 Suction system*
* Denotes parts that can only be purchased together and not individually.
CAUSE
1. The seal on the arm is backward
2. The seal and cap were not properly
cleaned
3. The O-ring and the connecting area were 3. Clean and properly lubricate
not cleaned properly.
4. Paint residue on connecting areas
5. The O-rings are damaged or missing
6. The roller cover is worn or damaged
7. The core or cap is worn or damaged
8. The bearing areas are worn
1. O-rings are not lubricated
³ Unscrew the locking cap on the valve housing by turning
Locking cap
· Remove the retaining disk and the duckbill from the valve
Retaining disk
» Clean these parts thoroughly using the appropriate
Duckbill valve
¿ Replace the duckbill valve and retainer disk.
Valve housing
´ Screw the locking cap on the valve housing by turning it
Connecting
area
Parts List (Fig. 19)
counterclockwise.
housing
cleaning solution
counterclockwise.
SOLUTION
1. Turn the seal around
2. Clean and properly lubricate
4. Clean connecting areas
5. Replace the O-rings
6. Replace roller cover
7. Replace core or cap
8. Call customer service
1. Lubricate the O-rings on the
plunger
1. Insert fill tube firmly into fill
valve and twist fill tube
several times to break up
paint residue.
2. If the problem persists, refer
to the steps below to clean
the fill valve components.
Part No.
0514118
0998230
0514150
0514112
9871022
------------
------------
0284398
0284395
0284435
0284293
GB
Qty.
1
1
1
1
2
1
1
1
1
1
1
5