Scheppach AB1900 Traduction Des Instructions D'origine page 30

Faulty power supply cables
Insulation damage often occurs at power
supply cables.
Causes are:
•
Pressure points when power supply ca-
bles are routed through the window or
door gaps.
•
Bends due to improper fastening or guid-
ing of the power supply cables.
•
Interfaces by running over the power
supply cables.
•
Insulation damage by pulling off the wall
outlet.
•
Cracks due to ageing of the insulation.
Such defective power supply cables must
not be used and are extremely dangerous
to life because of the insulation damage!
Check power supply cables regularly for
damage. Make sure that the power cable
is not connected to the mains supply when
you check.
Electrical connections must comply with the
relevant VDE and DIN regulations. Only use
connecting cables with H 07 RN-F mark.
An imprint of the type designation on the
power cable is mandatory.
AC motor
•
The mains voltage must be 230 V ~ / 50Hz
•
Extension cables up to 25 m length must
have a cross section of 1.5 mm
Power supply and extension cord must be
3-wire = P + N + SL. - (1/N/PE).
The mains supply is secured up to 16 A.
•
The product meets the requirements of
EN 61000-3-11 and is subject to special
connection conditions. This means that
30 GB
use of the product at any freely selecta-
ble connection point is not allowed.
•
Given unfavorable conditions in the pow-
er supply the product can cause the volt-
age to fluctuate temporarily.
•
The product is intended solely for use at
connection points that
a) do not exceed a maximum permitted
supply impedance "Z
b) have a continuous current-carrying ca-
pacity of the mains of at least 100 A per
phase.
•
As the user, you are required to ensure,
in consultation with your electric power
company if necessary, that the connec-
tion point at which you wish to operate
the product meets one of the two require-
ments, a) or b), named above.
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following information in
the event of any enquiries:
•
Type of current for the motor
•
Machine data - type plate
•
Motor data - type plate
.
2
If personnel qualified for unusual main-
tenance tasks or repairs must be ob-
tained during of after the warranty pe-
riod, please always contact a service
point recommended by us or contact
the manufacturer.
", or
max
Maintenance