Technical Data; Included In Delivery; General Safety Notes - Einhell Global SS-G 270 Mode D'emploi

Anleitung SS-G 270-12 sprachig
GB
USE
The orbital sander is designed for the
sanding of wood, metal, plastic and
similar materials when using the cor-
rect sanding paper.

Technical data

Voltage 230 Volts
Power consumption 270 Watts
Grinding surface area 225x 114
Sandpaper size 280x 114
Vibrations per minute 20,000
Sound pressure level LPA 78 dB(A)
Sound power level LWA 84 dB(A)
Vibration a w 10,1 m/s
Weight 2,2 kg
Totally insulated

Included in delivery

SS-G 270,
Dust bag
3 sheets of sandpaper

General safety notes

– Always remove the plug from the
power supply socket before carrying
out any maintenance or repair work
such as cleaning the sander or
changing the sandpaper!
– Always disconnect the machine by
removing the plug from the socket,
not by pulling on the mains cable.
– Always wear safety goggles and
dust mask when working.
– Keep the workplace clean and well
illuminated.
– Ensure that the workpiece is suffi-
ciently secured so that you are able
to work safety and effectively.
– Keep children away from the
machine.
– Always keep your machine clean,
and check for possible defects of
damage after every job.
– Always ensure that the switch is
switched off before you insert the
plug into the power supply socket.
– Ensure that any platforms you are
working on are sturdy and stable.
– If the machine is damaged, use the
exploded diagram and the spare
parts list to determine the precise
cause of the damage, and order any
neccessary parts from Customer
Service.
4
24.02.2000 16:29 Uhr
2
B
A
Seite 4
1 Front gripp
2 Machine identification
plate
3 On/Off trigger
4 Locking button
5 Main grip
6 Vibration plate
7 Clamping device
8 Vacuum cleaner
attachment
9 Electrical cord
Attaching the dust extraction
connector
Note!
For health reasons, you must use a dust
extraction device.
Warning!
– The pad sander is not designed
for wet sanding.
– When using a cable reel, make
sure to roll up the cable comple-
tely (wire diameter min. 1,5
mm 2 ).
– Disconnect the sander from the
power supply when work has
been completed.
– If the machine is defective, have
it serviced by a qualified dealer
immediately.
On/Off switch
On: Press trigger A.
Continuous Lock trigger A with locking
operation: button B.
Off: Briefly depress trigger A.