Starting, Stopping And Setting The Menu Limit; Cleaning, Care And Maintenance; Troubleshooting - Stiebel Eltron SHZ 30 LCD Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

Cleaning, care and maintenance

4.5.8 Displaying the service code
The service code gives the contractor information about the cause
of a fault (see chapter "Troubleshooting").
Service code display
4.6

Starting, stopping and setting the menu limit

To set the menu limit, hold down the
key for longer than 3 seconds until the
set temperature display flashes up.
hold
Set temperature symbol appears.
ECO mode symbol appears (flashes with
the ECO Plus and ECO Dynamic).
The set temperature is displayed with
the menu limit.
To switch off the menu limit, hold down
the key for longer than 3 seconds until
the mixed water volume display flashes
hold
up.
Menu limit on
All settings remain unchanged with the menu limit on.
You can make the standard settings for set temperature and rapid
heating with the keys (see chapter "Settings / Standard settings").
Menu settings are not possible.
In the menu limit display, the symbols for
heat-up, scale build-up and service/fault
appear as described in chapter "Settings
/ Controls and standard display".
34
| SHZ LCD
5.
Cleaning, care and maintenance
f Never use abrasive or corrosive cleaning agents. A damp
f
cloth is sufficient for cleaning the appliance.
f Check the taps/valves regularly. You can remove limescale
f
deposits at the tap outlets using commercially available des-
caling agents.
f Have the electrical safety of the appliance and the func-
f
tion of the safety assembly regularly checked by a heating
contractor.
6.

Troubleshooting

Fault
Cause
The water does not heat
There is no power.
up.
The outlet flow rate is
The jet controller in the
low.
tap or shower head is
scaled up or contami-
nated.
Scale build-up symbol
The flanged immersion
"Ca" appears.
heater is scaled up.
Service/fault symbol ap-
pears.
Service/fault symbol
flashes and the water
does not heat up.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the numbers
from the type plate (000000 and 0000-00000):
Remedy
Check the fuse/MCB in
your fuse box/distribu-
tion panel.
Clean and/or descale the
jet controller or shower
head.
Notify your local con-
tractor.
Notify your local con-
tractor.
It is essential to inform
your contractor.
Nr.: 000000-0000-000000
Made in Germany
www.stiebel-eltron.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Shz 50 lcdShz 80 lcdShz 100 lcdShz 120 lcdShz 150 lcd

Table des Matières