Attaching The Work Bowl Cover; Installing The Adjustable Slicing Disc - KitchenAid KFP0930 Manuel D'instructions

ASSEMBLING THE FOOD PROCESSOR
Attaching the wor_k bowl cover_
NOTE: Be sure to install the desired accessory before attaching the work bowl cover.
Place the work bowl cover on the work
1
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
NOTE: Your Food Processor will not operate unless the work bowl and work bowl cover
are properly locked on the base, and the large pusher is inserted to the maximum fill line on
the feed tube (approximately halfway down).

Installing the adjustable slicing disc

Hold the slicing disk by the finger grips
1
and lower it onto the drive adapter.
You may need to turn the disc/drive
adapter until it drops down into place.
TIP: You may need to turn the disc/adapter until it drops down into place.
W10625435A_v3.indd 9
Fit the food pusher into the 3-in-1
2
feed tube. See "Using the 3-in-1 Feed
Tube" for details on working with
different sized foods.
Install the work bowl cover, being sure
2
it locks into place.
9
7/29/13 11:22 AM