GreenWorks ELITE CS-80-XR-T Manuel Du Propriétaire page 24

MAINTENANCE
HOW TO SHARPEN THE CUTTERS
Be careful to file all cutters to the specified angles and to the same length, as fast cutting can be
obtained only when all cutters are uniform.
• Tighten the chain tension enough that the chain does not wobble. Do all of your filing at the
midpoint of the bar. Wear gloves for protection.
• Use a round file and holder.
• Keep the file level with the top plate of the tooth. Do not let the file dip or rock.
• Using light but firm pressure, stroke towards the front corner of the tooth. Lift file away from
the steel on each return stroke.
• Put a few firm strokes on every tooth. File all left hand cutters in one direction. Then move to
the other side and file the right hand cutters in the opposite direction. Occasionally remove
filings from the file with a wire brush.
PARTS OF A CUTTER
Top Plate
Rivet Hole
Heel
C A U T I O N
Dull or improperly sharpened chain can cause excessive motor speed during cutting which may
result in severe motor damage.
W A R N I N G
Improper chain sharpening increases the potential of kickback. Failure to replace or repair
damaged chain can cause serious injury.
Cutting Corner
Side Plate
Depth Gauge
Toe
Gullet
Right Hand
Cutters
24
Left Hand
Cutters