Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 25

OPERATION INSTRUCTIONS FOR GAS GRILL
Warning: Do not lean over grill when lighting. Read instructions before lighting.
Main Burners:
1. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
2. Light the match.
3. Immediately place the lit match through the 20mm hole on the side of the grill body, nearest
the left burner. Make sure the lit match is close to the burner ports.
4. Press in the control knob that operates the left main burner and rotate counterclockwise
to High position and burner should light immediately. The other main control knobs can
now be turned to the High position and will light via the crossover ports.
5. Adjust burners to desired cooking settings.
Side Burner:
1. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
2. Light the match.
3. Immediately place the lit match near the ignition wire located next to the burner.
4. Press in the control knob that operates the side burner and rotate counterclockwise
High position and burner should light immediately.
5. Adjust burner to desired cooking setting.
Main burner lighting
Turn off LP supply at cylinder when appliance is not in use.
Dual Fuel Grill
LIGHTING THE GAS GRILL WITH A MATCH
20mm hole
Side burner lighting
23
to