Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 24

OPERATION INSTRUCTIONS FOR GAS GRILL
GAS GRILL LIGHTING INSTRUCTIONS - FOR ALL BURNERS INCLUDING SIDE BURNER
Warning: Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the ignition control knobs are in the OFF position.
2. Open valve at tank fully by turning counter-clockwise
Always check the tank and hose connection before lighting.
3. Open lid during lighting.
4. Push and turn ignition knob counter-clockwise
5. Press ignition button until burner ignites. If ignition does not occur in 5 seconds, turn the control
to the OFF position, wait 5 minutes, and repeat the lighting procedure.
NOTE: If ignition does not take place within 5 seconds, immediately turn the ignition control knob
clockwise to the OFF position. Wait 5 minutes and repeat steps 4-5 above or refer to match
lighting instructions in manual.
If the burner still does not light, check that there is gas in the cylinder and follow the
match lighting instructions in the manual. Check the Troubleshooting Guide for
more information.
Dual Fuel Grill
Turn off LP supply at cylinder when appliance is not in use.
FOR OUTDOOR USE ONLY
.
to the ON position.
22