Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 17

Step 13: Attach right side shelf assembly (16).
Partially insert 3 screws (F) to the
grill body (13) as illustrated (leave
approximately 4-6mm between the
screw head and the surface of the
grill body (13). Align the keyholes
in the right side shelf assembly (16)
with the 3 screws just installed in the
grill body (13). Slide the right side
shelf assembly (16) onto the screws.
Secure the right side shelf assembly
(16) to the grill body (13) by inserting
2 additional screws (F) in remaining
holes. Tighten all 5 screws (F).
Hardware Used
F M6x16 Screw
Step 14: Install the heat tents (22) and the charcoal tray (25).
A. With the lids open, place the 2 heat tents (22) onto the
brackets directly above the burners located inside the
gas grill body as illustrated.
B. Place the charcoal tray (25) onto the charcoal lifting
frame, located on the inside of the charcoal grill body.
Step 15: Install the cooking grates (23) and warming racks (21).
A. Insert 2 cooking grates (23) on the gas grill body and 2
cooking grates (23) on the charcoal grill body.
B. Set one warming rack (21) on the gas grill body and one
warming rack (21) on the charcoal grill body.
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 5 pcs
16
15
16
F
22
25
21
21
23
23