Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 15

Step 10: Attach grill body (13). NOTE: 2 people are recommended
for this step.
Lock the back 2 casters to ensure the cart does not move
while installing the grill body (13). Carefully place the grill
body (13) on to the cart, making sure the LP gas hose is
inside the cart. Align the holes in the grill body (13) with the
holes in the cart side panels (4 & 5). Secure the grill body
(13) to the cart using 4 screws (E). Secure the grill body (13)
to the cart middle cross beam (32) using 2 screws (A).
Tighten all screws.
Hardware Used
A M6x12 Screw
E M6x20 Screw
Step 11: Attach charcoal tray adjustment handle (34).
Thread the charcoal tray adjustment handle (34) into the
hole in the right side of the grill body front panel. Once the
charcoal tray adjustment handle is threaded through the front
wall of the grill body, insert the cotter pin (I) into the hole on
the end of the charcoal tray adjustment handle from inside
the grill body.
Hardware Used
I Cotter Pin
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 2 pcs
Qty: 4 pcs
Qty: 1 pc
13
10
11