Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 14

Step 8: Attach the door assemblies.
Align the holes in the hinge of the left door assembly (8) to the holes
in the cart left side panel (4). Insert 4 screws (D) and tighten.
Attach the right door assembly (9) the same way. If interference
occurs between either the left or right cabinet doors and the cart
front vertical beam (29) when closing the doors, adjustment may
be needed. Widen the door opening by loosening the screws
that secure the cart left and right side panels (4 & 5) to the cart
bottom shelf (1), adjusting the gap and retightening the screws.
Hardware/Parts Used
D M4x10 Screw
Step 9: Attach lid handles (19).
Remove the pre-assembled screws (H) and the lid handle
bezels (20) from the lid handles (19). Align the lid handle
bezels (20) and the lid handle (19) with the predrilled holes in
the front of the left lid. Attach handle with 2 screws (H) from
the inside of the lid. Attach the right lid handle the same way.
Hardware Used
H M6x25 Screw
20 Handle Bezel
19 Lid Handle
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 8 pcs
Qty: 4 pcs
Qty: 4 pcs
Qty: 2 pcs
12
8
4
4
8
4
5
8 9
1
9
19
20