Dyna-Glo DGP700SSB Guide D'utilisation Et Mode D'emploi page 12

Step 4: Assemble cart rear vertical beam (30) and rear panels (6).
A. Using 2 screws (A) attach the cart rear vertical beam (30) to the
cart bottom shelf (1). Tighten the screws.
B. Partially insert 1 screw (A) to the cart left side panel (4) and 1
screw (A) to the cart right side panel (5) and 2 screws (A) to the
cart vertical beam (30). (Leaving approximately 4-6mm between
the screw head and the surface of the parts).
C. Align the keyholes in one of the cart rear panels (6) with 2 of the
screws just installed in the cart left side panel (4) and cart rear
vertical beam (30). Slide the cart rear panel (6) over the screws
and down to meet the cart bottom shelf (1). Secure the cart rear
panel (6) to the cart bottom shelf (1) using 2 screws (A).
D. Align the keyholes in one of the cart rear panels (6) with 2 of the
screws just installed in the cart right side panel (4) and cart rear
vertical beam (30). Slide the cart rear panel (6) over the screws
and down to meet the cart bottom shelf (1). Secure the cart rear
panel (6) to the cart bottom shelf (1) using 2 screws (A).
E. Tighten all screws (A) on the cart left side panel (4), cart right
side panel (5) and cart rear vertical beam (30)
Hardware Used
A M6x12 Screw
Step 5: Assemble cart front vertical beam (29), upper front door
brace (7) and cart middle cross beam (32).
A. Pre-assemble the cart front vertical beam (29), upper door front
brace (7) and cart middle cross beam (32) using 4 screws (A) -
forming the beam assembly. Tighten all screws.
B. Partially insert 2 screws (A) into the cart left side panel (4) and
2 screws into the cart right side panel (5), as illustrated (Leave
approximately 4-6mm of space between the screw head and
the surface of the parts). Align the keyhole slots in the pre-
assembled upper door front brace (7) of the beam assembly,
with the 4 screws just installed. Slide the upper door front
brace (7) down until snug. Tighten all 4 screws (A).
C. Fasten the cart middle cross beam (32) of the beam assembly
to the cart rear vertical beam (30) using 1 screw (A) and tighten.
D. Secure the cart front vertical beam (29) of the beam assembly
to the cart bottom shelf (1) using 2 screws (A). Tighten all screws.
Hardware Used
A M6x12 Screw
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Qty: 10 pcs
Qty: 11 pcs
10
4
1
4
30
A
1
5
29
7
A
30
5