BGS technic 9276 Mode D'emploi page 5

REMOVING
Clutch case can only be removed or installed with this special
tool.
Special tool must be fully attached onto the clutch case.
When needed, please rotate the transmission input shaft.
Push the auxiliary brake (B) to the top,
and use cable ties (C) to fix it.
Rotate the drive shaft (D) until the holes are aligned.
Use proper tool to check if the holes are connected.
Install the special tool (A) and rotate counterclockwise for
about 8 times to release the clutch.
Pull out the clutch from its case.
Place the transmission at the vertical position.
When the oil pump gear rotates along with the transmission,
the clutch is installed correctly.
After rotation complete, use special tool to install the clutch.
Rotate clockwise to its maximum position and use torque to
tighten.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed