Change Of Water - Hedson Drester GP 24 Mode D'emploi

11.5.4 WATER TEMPERATURE/
The water temperature is
adjustable between 30-50°C.
The heater can also be turned
off by decreasing temp until
OFF is shown in LCD.
The factory setting of the water
temperature is 45ºC. This value
may NOT be increased since the
water will be too hot and lead to
risk of burning injuries
11.5.5 TIME
It is important that time and
week day is correct since various
functions in the interface are
dependent on it.
11.5.6 FACTORY RESET
Use this to reset the machine
to factory standard. If you
accidentally entered the menu,
just press back or use the STOP-
button.
11.5.7 VERSION/MODEL
Shows what version of software
(SW) and hardware (HW) the
machine is using.
11.5.8 SELF TEST
The self test makes it possible to
run every function individually
in the machine. It is used i.e.
when new options are installed,
to control that they are working
properly. It can also be used for
troubleshooting the machine.
The self test should only be
used by authorized personnel.
11.5.9 ALARM LOG
The alarm log saves all error
codes. The errors will be
displayed in the LCD when they
occur. These error codes are
saved to an alarm log where
you can go back and see type of
error code, how many days ago
it occurred and the time.
See chapter 19 Trouble
Shooting, for error code list.
11.5.10 LANGUAGE SELECTION
Change the display language
230754-EN rev.1 2016-12-15
GP 24
HEATER

12. CHANGE OF WATER

After washing 300 wheels, the water must be changed
and the machine cleaned.
PLEASE NOTE: If moving the unit filled with water, the
forklift must reach all the way under the machine (see
picture 1) and under the crossbeam (see picture 2).
1. Top up with water until the water level reaches the
upper notch of the red level indicator (see picture 12
and 13). Place the shot medium basket in the wash
compartment and close the door. PLEASE NOTE:
Place the shot medium basket with the side opening
to the left (see picture 17).
2. Press the shot medium collection button (see
chapter 10) and let the machine run until it stops
automatically
(approx. 5 min). Confirm that water level is raised
by pressing ENTER. If needed, run this shot medium
collecting program twice.
As the shot medium is collected in the basket, you
can easily check that you have the correct amount of
shot medium, by checking that the shot medium level
reaches the 20 kg marking on the side of the basket
(see picture 17). If this is not the case, top up with
more shot medium.
3. PLEASE NOTE: Always turn off the main switch
before emptying out the water in the machine!
Let the water out by putting the lower drain hose on
the floor (see picture 3). The waste water from this
machine should be let out through an oil separator.
If required, the machine can be equipped with an
environmentally friendly water cleaning and filtering
system. It will separate the waste and the water, so
that the water can be emptied into the drain. After
having used the Hedson Water cleaning system, the
waste water fulfils all water authority requirements.
Please contact your local water authorities for more
information about local limit values.
4. Remove the dirt sediment from the bottom of the
machine with a hand bailer and then rinse the
machine. PLEASE NOTE: The residues from the
machine must be handled as hazardous waste.
Put the shot medium back into the water by turning the
basket over inside the machine and top up with water
until the lower notch of the red level indicator is reached
(see picture 13).
PLEASE NOTE: Always turn off the main switch before
emptying out the water in the machine! The heater will
automatically be turned on again after starting a wash
cycle.
9