Korg KAOSS DJ Manuel D'utilisation page 9

Balance knob toward the Master side.
3. Use the headphone knob to adjust the
headphone volume.
TIP By pressing the headphone cue button while
holding down the Shift button, you can switch
the level that's indicated by the level meter.
Input A/B
Master Out L/R
EQ
Turn the EQ knobs to adjust the tonal charac-
ter. Turning a knob toward the right boosts the
sound of that frequency region; turning it
toward the left cuts the sound.
Filter
Slide your finger across the touch slider to
control the filter. The left side is a low-pass
filter, and the right side is a high-pass filter. In
the center, no filter is applied.
TIP Touching the touch slider while you hold down
the Shift button will also cause no filter to be
applied.
3. Using the Kaoss effects
Turning the Kaoss effects on/off
Selecting the deck where the Kaoss effect is applied
Press the Fx button of the deck where you
want to apply the effect; the button light up and
the effect turns on. If you turn on the effect for
both decks, the effect applies to the master
output after deck A and deck B are mixed. If
you turn off the effect for both decks, the
sound without the effect is output.
Selecting an effect program
Turn the program/value knob to select the
effect program that you want to use.
TIP For details on the effect programs, refer to the
program list.
Using the touchpad to apply an effect
Perform by using your finger to rub or tap the
touchpad.
Do not use any hard or pointed object. Do not use
the touchpad with anything other than a fingertip,
and do not wear gloves.
1. The effect is applied when you touch the
touchpad.
2. The effect disappears when you take your
finger off the touchpad.
TIP If you press the Hold button to turn it on, the
effect that was applied immediately before you
released your finger is maintained.
Adjusting the depth of the effect
To adjust the effect depth (FX DEPTH), hold
down the Shift button and move your finger left
or right on the touchpad.
Setting the BPM (tempo)
Here's how to specify the tempo that's used by
some programs such as delay.
1. Press the Tap button to get the BPM indica-
tion.
2. You can use the program/value knob to
change the value.
Tap tempo
After pressing the Tap button to make the
display indicate BPM, press the Tap button
several times at the appropriate interval to
specify the BPM.
Auto BPM
You can press an Fx button to select a deck,
and with audio being input, long-press the Tap
button to auto-detect the beat of the song and
assign it as the BPM value.
To exit auto BPM, long-press the Tap button
once again. The BPM value when you exited
is assigned as the setting.
TIP If the BPM cannot be detected, press the Tap
button several times at the beat of the song,
and the BPM is automatically detected with that
beat as a guideline. Due to the characteristics
of auto BPM, the value might be set to 1/2 or
2/3 of the correct BPM, or might be slightly
inaccurate; in such cases you can use the Tap
button to correct the setting manually.
TIP The BPM value cannot be detected for music
that does not have a clear sense of beat. The
range of detection is 80–160.
TIP If BPM cannot be detected, such as when there
9