Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Before You Start The Refrigerator; Electrical Connection - Beko DN162230DJIZX Mode D'emploi

3

Installation

B
In case the information which are given
in the user manual are not taken into
account, manufacturer will not assume
any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1.
Your refrigerator should be unplugged.
Before transportation of your refrigerator, it
should be emptied and cleaned.
2.
Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with adhesive tape
and secured against impacts. Package should
be bound with a thick tape or sound ropes
and the transportation rules on the package
should be strictly observed.
3.
Original packaging and foam materials
should be kept for future transportations or
moving.
Before you start the
refrigerator,
Check the following before you start to
use your refrigerator:
1.
Attach 2 plastic wedges as illustrated
below. Plastic wedges are intended to
keep the distance which will ensure the
air circulation between your refrigerator
and the wall. (The picture is drawn up as a
representation and it is not identical with your
product.)
2.
Clean the interior of the refrigerator as
recommended in the "Maintenance and
cleaning" section.
3.
Connect the plug of the refrigerator to the
wall socket. When the fridge door is opened,
fridge internal lamp will turn on.
4.
When the compressor starts to operate,
a sound will be heard. The liquid and gases
sealed within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is quite normal.
5.
Front edges of the refrigerator may feel
warm. This is normal. These areas are
designed to be warm to avoid condensation.

Electrical connection

Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily accessible
after installation.
• Electrical safety of your refrigerator shall be
guaranteed only if the earth system in your
house complies with standards.
• The voltage stated on the label located at
left inner side of your product should be
equal to your network voltage.
9
EN