Operation, Setting Speed (Depending On Equipment); Operation, Fitting Tools; Fitting Cutting And Grinding Discs; Securing/Releasing The Quick Clamping Nut (Depending On Equipment) - Metabo W 7-100 Mode D'emploi

02 ENG_Paddle_8830_0108
If switched on continuously, the
machine continues running if it is
jerked out of your hands. Therefore,
always hold the machine with both
hands on the handles, stand safely, and
concentrate on your work.
Restart safety device
(only with VTC / TC electronic system):
If the mains connection is made with the angle
grinder still switched on or if the power supply is
restored after an interruption, the angle grinder
will refuse to start. The red electronic system
indicator (6) flashes. Switch angle grinder off and
then on again.
9 Operation, Setting Speed
(depending on equipment)
Set the recommended speed with the knurled
wheel (7).
Grinding disc, cutting disc, cup grinding
wheel: high speed setting
Brush: middle speed setting
Surface dressing discs: low to middle speed
setting
Apply only light pressure to the tool when working
at low speeds.

10 Operation, Fitting Tools

Before any tool changing operation,
always remove the plug from the mains
supply socket and check that the angle
grinder is switched off and that the
spindle has come to a halt.
Locking the spindle
Press in the spindle-lock button (2) and turn the
spindle by hand until the spindle-lock button can
be felt to engage in position.
10.1

Fitting cutting and grinding discs

Locate the inner flange (10) on the spindle, as
illustrated, ensuring that the inner flange cannot
turn on the spindle.
22.01.2008 11:24 Uhr
Position the cutting disc or the grinding disc on
the inner flange, as illustrated, ensuring that the
cutting disc is supported evenly by the inner
flange. When cutting, the sheet metal flange on
the cutter disc should be resting on the inner
flange.
10.2
Securing
Fit the Quick clamping nut (11) in the grooves on
the spindle as illustrated. Lock the spindle in
position. Turn the Quick clamping nut (11)
clockwise by hand until tight. Tighten the Quick
clamping nut by turning the grinding wheel firmly
in a clockwise direction.
Releasing
After switch-off, the angle grinder runs on for
approx. 5 seconds. Press the spindle-lock button
(2) shortly before the grinding tool comes to a
final halt and the Quick clamping nut releases
itself.
Screw the Quick clamping nut off.
10
10
Seite 17
Securing/releasing the Quick clamping
nut (depending on equipment)
11
For tools which are thicker than 8 mm
(5/16") in the clamping area, use the
clamping nut (12) with the pin spanner (13)
instead of the Quick clamping nut (11).
Using the spindle-lock button (2) to stop
the spindle is only permitted if the
Quick clamping nut is in use!
ENGLISH
17