Radio mode
Switching to radio mode
If you are in CD, CD changer or AUX mode,
u
press the BND button =
or
u
press the SRC button 2 repeatedly
until the display shows "FM1", "FM2",
"FMT" or "AM".
Selecting the waveband/memory
bank
This device can be used to receive stations
in the FM and AM frequency bands. There
are three memory banks available for the
FM waveband (FM1, FM2 and FMT) and
one for the AM waveband.
Five stations can be stored in each memory
bank.
To switch between the memory banks FM1,
FM2 and FMT or the AM waveband,
press the BND button =.
u
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
u
Press the
or
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
To change the set frequency in small incre-
ments,
u
briefl y press the
14
button 4.
or button 4.
To change the set frequency quickly,
u
press and hold down the
4 for a longer period of time.
Setting the sensitivity of station
seek tuning
You can choose whether the radio should
only tune into stations providing good re-
ception or whether it can also tune into
those with a weak reception.
u
Press the MENU•OK button 5.
u
Press the
or
until "SENS HI" or "SENS LO" appears
on the display.
"SENS HI" indicates the highest sensitivity,
"SENS LO" the lowest.
u
Set the desired sensitivity with the or
button 4.
When you have fi nished making your chang-
es,
u
press the ESCAPE button <.
Note:
The device stores the sensitivity value
set in the respective FM and AM wave-
band.
Storing stations
Storing stations manually
u
Select the desired memory bank FM1,
FM2, FMT or the AM waveband.
u
Tune into the desired station.
u
Press and hold down one of the station
buttons 1 - 5 9 for longer than two
seconds to assign the station to that
button.
or button
button 4 repeatedly