Trixie TX5+1 Mode D'emploi page 4

E Instructions
• Read the manual before using the device.
• Only use the automatic feed dispenser with feed bowl and lid.
• Do not use the device with puppies or kittens under the age of 7 months.
• Place the automatic feed dispenser on a level surface.
• The automatic feed dispenser is only suitable for indoor use.
• Do not allow your pet to gnaw on the device or the cable. Use a cable
guard if necessary.
Before using the auomatic feed dispenser
1. Connect the USB cable to the automatic feed dispenser and a power
source to supply the device with electricity. As an alternative, insert 3 ×
C-Mono batteries into the bottom of the device.
2. Should the batteries be empty, a small light on the automatic feed dispen-
ser will flash.
3. Press on the lid of the device with both hands and turn it in the direction
of the arrow on the lower part. When the arrows on the bottom and top
parts meet, you can lift the lid off.
4. The feed bowl can be removed in the same way. For this, the arrow below
the display has to point to the arrow on the feed bowl.
5. Now fill in the desired number of portions and lock the lid by turning it again.
6. Switch on the main switch at the bottom.
7. Next press the key to start a test run.
Key Lock
To release the key lock, press the keys and simultaneously for one
second. If no settings are made to the automatic feed dispenser for 30
seconds, key lock is activated automatically.
Programming the Feeding Times
Setting the time:
1. Press for setting the time so that the digits on the clock begin to flash.
2. Now set the current time with the arrow keys.
3. Save this by pressing the Settings key .
Setting feeding times:
1. After you have set the time, the no. 1 is flashing together with the time.
Now you can set the first feeding time.
2. Press to save. This automatically takes you to the next feeding time.
4