Dyna-Glo DGX780BDC-D Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
CAUTION: This unit is HEAVY! Do not attempt
3.
this step without assistance!
With the assistance of a helper, stand the unit
(Make sure that the legs are attached.) Place the
upper (P) and lower (Q) doors back onto the
hinges of the smoker body (G).
4. Attach the side dampers. Dampers (K) are
installed from the inside of smoker body (G).
Thread the damper handle through the back hole
of the side damper slots. Align the damper (K)
with the mounting holes and insert four M5x12
screws (BB) from the outside of the smoker
body (G). Secure each bolt with M5 nut (EE) from
the inside of the smoker body (G). Use a Phillips
screwdriver and wrench to tighten the nuts and
bolts. Do not over-tighten. Damper must be able
to slide easily from side-to-side.
Hardware Used
M5 x 12mm
BB
Shoulder
Screw
EE
M5 Nut
x 8
x 8
7
3
G
P
Q
4
EE
G
K
BB