Connecting The Awning - Dometic PERFECTWALL PW 3800 Instructions De Montage

PW3800
➤ Drill one hole with a diameter of 3 mm through the awning and each of the short
mounting plates (fig. d, page 2).
➤ Fasten the awning with drill screws (fig. d, page 2).
Installing the mounting bracket
The mounting bracket must be installed if the awning is to be attached to the side of
the vehicle when extended.
➤ Select the location of the installation.
➤ Mark where the holes are to be drilled.
➤ At the marked points, drill holes with a diameter of 3 mm from the outside into
the external wall (fig. e, page 2).
➤ Put the upper and lower sections of the mounting bracket together.
➤ Clean the outer sides of the lower section and the installation surface in the
vehicle.
I
NOTE
Make sure that no glue gets on to the movable upper section of the
mounting bracket.
➤ To glue and seal, apply an elastic adhesive, such as Sikaflex
the back of the mounting bracket.
➤ Fasten the mounting bracket with drill screws (fig. e, page 2).
or
➤ Rivet the mounting bracket (fig. e, page 2).
Installing the crank bracket
➤ Mount the mounting bracket for the crank at a suitable location inside the vehicle
(fig. f, page 2).
7

Connecting the awning

!
WARNING!
• Disconnect the power supply before starting the assembly.
• Only permit a qualified electrician to connect the awning to the elec-
trical power.
EN
Connecting the awning
®
-221 for example, to
9