Intex PureSpa Mode D'emploi page 12

Spa Control Unit Installation
Connect the spa control unit to the spa tub (see drawing 10). Hand-tighten the connectors securely.
1.
Do not use tools to tighten.
Reinstall the back cover (2) to the spa control base (see drawing 11). Back cover must be installed
2.
before using the SPA.
CAUTION: Do not sit, lean, cover or place any objects over the spa control unit.
B
B
A
A
C
C
Attach the fi lter cartridge housing assembly to the inside of the spa
3.
tub outlet grid (lower position, marked "C") (see drawing 12). Infl ate
the spa tub fi rst before installing fi lter pump fi ttings.
Before fi lling with water ensure the bottom drain valve caps are
4.
securely closed on the inside and outside.
Fill the spa tub with freshwater to a level between MIN and MAX
5.
marked on the inside of the spa wall. Do not over fi ll the spa.
Never move the spa tub with water inside and/or with the control
base attached to the spa as the spa or control base may be
damaged.
WARNING: Never pour water with a temperature higher than
40°C (104°F) into the spa directly. It is recommended to fi ll the
spa tub with lukewarm water for quick heating and energy saving.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
6.
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
Ensure the spa is plugged into a electrical socket and press the
7.
panel buttons fi rst. Press the
Unit Panel" operation section.
S AVE THESE INSTRUCTIONS
(295IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/06/2017
SET UP (continued)
10
button on the control panel to activate the heater, see "Spa Control
English
11
2
C
button to turn on the control unit
Page 12
295
A
12