Intex PureSpa Mode D'emploi page 10

Press the button to turn on the control unit panel
5.
buttons fi rst. Press the
spa tub wall for 8 to 10 minutes until it is fi rm to the touch
but not hard (see drawing 6).
IMPORTANT: Do not over infl ate or use high pressure air
compressor to infl ate.
Press the button again to turn it off.
6.
Replace the air valve cap back.
7.
NOTE: The cap is designed to be screwed on and off.
Never exert force as this could cause the complete
internal infl ation system of the valve to come loose. See "Spa Tub Air Valve Fastening" for valve
maintenance.
Infl ate the Spa Cover Air Bladder
Open the infl ation valve and insert the infl ation
1.
hose (7) into the valve; press
until it is fi rm to the touch but not hard (see
drawing 7).
Disconnect the infl ation hose (7) from the air
2.
blower infl ation outlet and the valve.
Replace the control base infl ation cap (5)
3.
back; close and recess the infl ation valve.
NOTE: If there is a need to add some air to the spa tub wall or spa cover air bladder after they have been
setup, refer to above "Infl ate the Spa Tub Wall" and "Infl ate the Spa Cover Air Bladder" sections. The cover
air bladder is preinstalled inside the spa cover. If it needs to be reinstalled, place the uninfl ated air bladder
inside the spa cover lip before infl ating the bladder.
Defl ation
For Spa Tub Wall:
Unscrew the cap to reveal the stem, push the stem in
1.
and turn 90 degree right to secure it in the down
position (see drawing 8).
Once the defl ation is completed, push the stem in and
2.
turn 90 degree left to return it to the infl ation position.
Replace the cap back.
3.
For Cover Air Bladder:
Pull valve cap out and squeeze the valve at its base until
1.
defl ated.
Close and recess the valve back.
2.
S AVE THESE INSTRUCTIONS
(295IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/06/2017
SET UP (continued)
button to infl ate the
to infl ate
English
7
Page 10
295
A
6
7
8